Cross Stitch Lacing Tutorial

02 Aug Cross Stitch Lacing Tutorial

Cross Stitch Lacing Tutorial Part 2

Hi, I’m Nikki from Cross Stitch Supplies.

So now that we’ve pinned it we can turn our work over – keep that centre pin in and try to push it all the way through.
And flip over your work. Now we’re going to take our cotton and this is when we need to learn how to do a slip knot. We’re going to make a loop, twist it and pull the thread through the loop.
It’s a knot that shifts as you pull it. You don’t want it too tight otherwise you can’t lock it and you don’t want it too loose otherwise it will just slip out. So first we need to anchor our thread onto our fabric. We are going to pull it through like that until we have a little tail and then we’re going to do our slip knot like that and we’re going to pass our needle through the slip knot.
Now this is the most important part – we need to lock that thread in place. We’re going to pull it through and there – where it pulls through the other side, it’s locked. You can tighten it if you want. Now we are going to continue lacing from the bottom – leave two or three cm’s space and push it through.
The same at the bottom. Now we need to attach a piece again – make another slip knot. The end goes through there and we tighten it. Now we are going to pull the top thread on each leg – you can see I’m giving it tension but not too much that it distorts the fabric.

So I pull it and them I’m holding it there and then I pull the next one and I keep doing that all the way along. Once you get a knot just wiggle it through. Now we’ve got the tension we want, pull that up and I’m just going to tie it off. No fancy knot or anything. Lots of knots so they don’t slip out. Now we can see that it’s tensioned we can go and cut off the extra bits if we want to.
Now that we’ve lace one whole side, we’ve rotated our project and we’re going to fold over the top like that. Make a neat corner and we’re going to lace through two layers there. Pull it through and do our slip knot. And we’re going to fold over this side as well. Through two layers. And now we start again.

The last one! Trying to keep as much tension in the last one as possible. And now we can take the pins out.

Turn it over and take out the pin in the middle and there we have our finished product.

No Comments

Post A Comment